Confirmation Of Projector Status - Mitsubishi Electric LAN Control Utility User Manual

Lan control utility
Hide thumbs Also See for LAN Control Utility:
Table of Contents

Advertisement

5. Operation of projector

5.2. Confirmation of projector status

The status of the projector is displayed on the projector list on the main screen.
Item
Check
No.
Projector Name
MAC Address
IP Address
Power
Input Source *
1
AV Mute
Lamp 1/2 Time (Low)
Group Name
*
HDMI and DVI-D are displayed with DIGITAL 1 or DIGITAL 2 by a connected projector.
1
<Note>
• The default cycle of the automatic re-acquisition is 10 minutes. To change this cycle, see "3.1. System
settings."
• The status of Input Source and AV Mute will not be obtained under the following conditions:
- when the projector is powered off
- during warm-up or cool-down.
• When multiple projectors are connected, it may take time to acquire the status. During acquiring the status,
the status bar at the lower part of the main screen becomes "Getting status...", and it becomes "Done" when
the acquisition has been completed.
Description
Theft detector setting (ON/OFF)
Projector list registration number
Projector name set in the application
MAC address of the projector
IP address of the projector
Power supply status of the projector (ON/OFF)
Input signal of the projector (COMPUTER 1/COMPUTER 2/VIDEO/S-VIDEO/
HDMI (HDMI1/HDMI2)/DVI-D/SDI/PC Less Presentation/USB Display/LAN
Display/COMPONENT)
Mute status of the projector (ON/OFF)
Lamp illuminating time (HHHH:MM)
In the case of the projector equipped with two lamps, illuminating time for
the lamp 1 is displayed in the left side and illuminating time for the lamp 2 is
displayed in the right side.
The belonging group of projector
EN-16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Projectorview global+

Table of Contents