Table of Contents
Advertisement
5 Basic Operation
5 Basic Operation
5-1 DIP Switch Settings
DIP switch
SW-1
SW-2
SW-3
SW-4
SW-5
SW-6
SW-7
SW-8
SW-9
SW-10
All DIP switches are set to OFF when shipped from the factory.
The DIP switches are located on the right face of the unit, near the bottom.
SW-1–4 : Sets the communication parameters for a serial connection. When the PNC-5000 is connected to the computer through the
serial port, be sure that the communication parameters for SW-1 to SW-4 are set correctly, matching the computer port
settings.
(Data length is fixed to 8 bits.)
SW-5
: Detects automatically the front edge of loaded material. To detect the front edge of loaded material, set SW-5 to ON (en-
abled).
SW-6
: Detects length of cut material automatically. Switch to ON (enabled) when loading sheet material, and OFF (disabled) when
loading roll material.
SW-7
: Sets the amount of offset for the cutter blade. Set to OFF when using a tool with a blade offset of 0.25 mm, or to ON when
using a tool with a blade offset of 0.5 mm.
SW-8
: Sets the weight of the material. SW-8, which controls the material weight, should normally be set to OFF (light). Cutting
speed slows down when switch is turned ON, but the force used to move the material and the blade increases.
SW-9
: Switch on if wish for crop marks to be printed automatically. Switch off to avoid crop marks.
5-2 Powering On
Press the side of the
switch marked " | ".
6
Function
OFF
Baud rate
9600
Parity
Disable
Parity
ODD
Handshake
Hardwire
Front edge sense
Disable
Cut sheet mode
Disable
Blade offset
0.25
Long output mode
Light
Crop mark mode
OFF
(Not Used)
–
* Option required; please consult your dealer.
ON
NOTICE
19200
DIP switches settings must be made only
Enable
when the power is turned off.
EVEN
XON/XOFF
Enable
Enable
0.5*
Heavy
ON
–
When the power switch is pressed to power on the unit, the
tool carriage moves. Use caution to ensure that your hands or
other objects do not become caught in the moving parts.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorCAMM PNC-5000 and is the answer not in the manual?
Questions and answers