Basic Operation; Dip Switch Settings; Powering On - Roland Color CAMM PC-50 User Manual

5 Basic Operation

5 Basic Operation

5-1 DIP Switch Settings

DIP switch
SW-1
SW-2
SW-3
SW-4
SW-5
SW-6
SW-7
SW-8
SW-9
SW-10
All DIP switches are set to OFF when shipped from the factory.
The DIP switches are located on the right face of the unit, near the bottom.
SW-1–4 : Sets the communication parameters for a serial connection. When the PC-50 is connected to the computer through the serial
port, be sure that the communication parameters for SW-1 to SW-4 are set correctly, matching the computer port settings.
(Data length is fixed to 8 bits. It is automatically determined whether the number of stop bits is 1 or 2.)
SW-5 : Detects automatically the front edge of loaded material. To detect the front edge of loaded material, set SW-5 to ON (en-
abled).
SW-6 : Detects length of cut material automatically. Switch to ON (enabled) when loading sheet material, and OFF (disabled) when
loading roll material.
SW-7 : Sets the amount of offset for the cutter blade. Set to OFF when using a tool with a blade offset of 0.25 mm, or to ON when
using a tool with a blade offset of 0.5 mm.
SW-8 : Sets the weight of the material. SW-8, which controls the material weight, should normally be set to OFF (light). Cutting
speed slows down when switch is turned ON, but the force used to move the material and the blade increases.
SW-9 : Acclimates the machine and the material before cutting or printing, which can produce more attractive printing or cutting
results. This is normally set to OFF (enabled).
(When the cut-sheet mode (SW-6) is set to ON (enabled), the prefeed mode is disabled, regardless of the setting of SW-9.)

5-2 Powering On

Press the side of the
switch marked " | ".
6
Function OFF
Baud rate 9600
Parity Disable
Parity ODD
Handshake Hardwire
Front edge sense Disable
Cut sheet mode Disable
Blade offset 0.25
Long output mode
Light
Prefeed mode
Enable
(Not Used)
–
ON
NOTICE
19200
DIP switches settings must be made only
Enable
when the power is turned off.
EVEN
XON/XOFF
Enable
Enable
0.5*
*This option should be selected only when you are using
optional blade, ZEC-U3050.
Heavy
Please contact your dealer for more information.
Disable
–
When the power switch is pressed to power on the unit, the
tool carriage moves. Use caution to ensure that your hands or
other objects do not become caught in the moving parts.