Grill Controls; Master Power Switch; Indicator Lights; Display - Garland MASTER SERIES XG24CE GB/IE Installation & Operation Manual

GRILL CONTROLS

CANCEL/
RAISE PLATEN
BUTTON
MASTER
POWER
SWITCH

Master Power Switch:

Controls power to the grill and must be turned "ON" to start
operation. The controller display will be active when the
switch is "ON".

Indicator Lights:

There are two, (2), indicator lights, indicating the
temperature status of each control's heat zones; one, (1), on
the upper platen, (top light), and one, (1), on the grill surface.
Each light can display three, (3), different colors, indicating
temperature status for the corresponding zone.
Red: The zone is too hot, (more than 79°F/45°C over the set
temperature), or heat zone failure.
Amber: The zone is calling for heat.
Green: The zone is at or above the set temperature.
Page 10
WHEN PUSHED SIMULTANEOUSLY:
"START COOK TIME COUNTDOWN" ( at grill cooking)
OR "LOWER PLATEN" (two-sided cooking)
ON
OFF
POWER
BUTTON
PROGRAM
BUTTON
TEMPERATURE
BUTTON
READY
INDICATORS

DISPLAY

ENTER
BUTTON
DOWN ARROW
BUTTON
UP ARROW
BUTTON
Display:
The controller display will contain information relevant to
each operation in both cook and program modes.

Gap Setting Buttons (1-5):

For two-sided recipes, the desired gap button is pressed
before the cook cycle begins to set the gap. Hold buttons
1-5 to apply gap settings 6-10. The chosen gap button and
its value will be displayed. Until a different menu item is
selected, (or the current item is changed and then returned
to), the Gap Button only needs to be pressed before the
initial cook.

Gap Button:

When in programming mode, press the Gap Button to set
the values for Gap Buttons 1-10. Press Enter to accept the
changes. After going through all ten, you will return to
Programming Mode.
GAP
SETTING
BUTTONS
GAP
BUTTON
Part # 4517127 (06/23/08)