Ne100-4F, Ne100-4Fs, And Ne100-4Fs4 Front Panel View; Ne100-4F/Ne100-4Fs/Ne100-4Fs4 Switch And Function Of Led Indications; Connector Specifications For Ne100-4F, Ne100-4Fs, And Ne100-4Fs4; Name Of Switch And Led - Hitachi GR2000 Series Installation Manual

GR2000 Installation Guide
3.5.2 NE100-4F, NE100-4FS, and NE100-4FS4
The NE100-4F, NE100-4FS, and NE100-4FS4 physically appear as Figure 3-23.
These NIFs each have four ports for connection with pairs of SC 2-core optical fiber
connectors (transmit and receive). Table 3-18 shows the connector specifications.
Figure 3-23 NE100-4F, NE100-4FS, and NE100-4FS4 Front Panel View
Switch and LED indication
Table 3-17 NE100-4F/NE100-4FS/NE100-4FS4 switch and function of LED indications
Name of switch
Nam
and LED

STATUS

LED: Green/

Yellow/ Red
LINK LED: Green
LINE ERR LED: Red
T/R LED: Green
Table 3-18 Connector Specifications for NE100-4F, NE100-4FS, and NE100-4FS4
NIF
NE100-4F
NE100-4FS
NE100-4FS4
3-20
TX RX
LINE ERR
LINK
T/R
LINE 3
Status

Shows the operating

condition of RP.
Shows the operating
condition of each line.
Connector Specifications
SC 2-core (flat) connector (multimode fiber, 1300 nm wavelength)
SC 2-core (flat) connector (single-mode fiber, 1300 nm wavelength)
SC 2-core (flat) connector (single-mode fiber, 1300 nm wavelength)
TX RX
TX RX
LINE 2 LINE 1
Content

Green: Operable operation

Yellow: Blocking and cock insertion and removal

possible.

Green blinking: Under preparation (being started up.)

Red: Fault

Extinguished: Operation not possible (Including the

device power supply being turned off)

Ring pulse of 100BASE-FX/FX (middle)/FX (long) is
being established.
100BASE-FX
TX RX
LINE 0
GR2K-GA-1002
Rev. 6.03