Reset - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 11: Basic Commands Command List

reset

Description
The reset config system command provide reset functions. The configuration setting will be reset to the
default setting. For the "save system" command, the device will store the reset setting in the NVRAM
and then reboot the system.
The configuration settings include enable/disable of clipaging, greeting message, and command prompt
will also be reset by all the reset commands.
There is one exception, the "reset" command will not reset IP address configured on the system IPIF
and the default gateway setting.
Format
reset {[config | system]} {force_agree}
Parameters
config - (Optional) If you specify the 'config' keyword, all parameters are reset to default settings.
●
But device will not do save neither reboot.
system - (Optional) If you specify the 'system' keyword, all parameters are reset to default settings.
●
Then the switch will do factory reset, save and reboot.
force_agree - (Optional) When force_agree is specified, the reset command will be executed
●
immediately without further confirmation.
Restrictions
Only Administrator-level users can issue this command.
Example
To reset the switch:
EAS 200-24p:admin#reset system
Command: reset system
Are you sure you want to proceed with system reset?(y/n)
y-(reset all include configuration, save, reboot )
n-(cancel command)y
Reboot & Load Factory Default Configuration...
Saving configurations and logs to NV-RAM...... Done.
Please wait, the switch is rebooting...
226
Extreme Networks EAS 200-24p Switch CLI Manual