Checking Jumper Settings; Jumper Settings - ECS 945GCT-M2 Manual

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is labeled.

Jumper Settings

Type
Jumper
Description
CLR_CMOS 3-pin Clear CMOS
Front Panel
USBPWR_F 3-pin USB Power
Select Jumper
Rear USB PS/2
USBPWR_R 3-pin Power Select
Jumper
1. To avoid the system unstability after clearing CMOS, we recommend users
to enter the main BIOS setting page to "Load Optimal Defaults" and then
"Save Changes and Exit".
2. Make sure the power supply provides enough 5VSB voltage before select-
ing the 5VSB function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto 2-
3 pin rather than 1-2 pin as default if you want to wake up the computer by
USB/PS2 KB/Mouse.
Installing the Motherboard
Setting (default)
1-2: NORMAL
2-3: CLEAR CMOS
Before clearing the
CMOS, make sure to
turn off the system.
1-2: VCC
2-3: 5VSB
1-2: VCC
2-3: 5VSB
9
1
CLR_CMOS
1
USBPWR_F
1
USBPWR_R