Adjusting The Toeplate; Changing The Decorativepanel - Whirlpool 800 SERIES Use & Care Manual

5. Plug into a grounded 3 prong outlet.
6. Determine if you want the compactor frame or drawer front flush
with the cabinet front,
Using the two #8 -18 x -_6"screws, install the retaining brackets
to cabinet top as needed:
If the compactor frame is to be flush with the cabinet front,
place retaining bracket screws through "A".
If the compactor drawer front is to be flush with the cabinet
front, place retaining bracket screws through "C".
If the compactor is to be midway between "A" and "C",
place retaining bracket screws through "B".
countertop
Adjusting the ToePlate
If the toe plate rubs the floor covering, the toe plate clearance
may be changed as follows:
f. Mark on each side of the toe plate the amount of toe plate
that rubs the floor covering.
2. Remove the drawer from the unit. (See step 3 in the
"Unpacking Your Compactor" section.)
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat
steps 1-4.
7, Carefully lift the front slightly and roll compactor into the
cabinet opening.
Using the two #8 -18 x _" screws, fasten the retaining brackets
to the underside of the countertop with the mounting screws.
If brackets cannot be attached to the underside of
countertop, attach mounting clips to brackets. Fasten
compactor to cabinet front with mounting screws through
mounting clips.
retaining
bracket
mounting
screw
Countertop mounting
retaining
• bracket
mounting
clip
Cabinet-frent mounting
8. Grasp sides of compactor drawer and place bottom
of drawer into tracks. Lift at the handle so drawer will go over
drawer stops. Close drawer. Check if drawer opens freely. If
the toe plate rubs against floor, see "Adjusting the Toe Plate"
for further instructions.
Changing the DecorativePanel
Custom-made panel dimensions
23,3/,,,
(60.5 cm)
,!
14%"
7 ,, (37.2 cm) /
Flat panel: A _2 (5.6 mm) thickpanel is required,This is the
same thickness as a standard ¼ plywood or paneling.
panelor l[ 11 I I I
decorativeII II 1I I
trim II II I I 23,3_,,,
II II I I (6o.5 cm)
outer,,c.on--t III I I I
(_'mm) _',L_
both sides-- I (8 mm)
Raised panel: The outer section of panel must be _2" (5.6 mm)
thick to fit into trim, Design raised panel sections using dimensions
shown above.
7