Advertisement
"No WORRY" BATTERY B ACKUP
This clock radio is equipped with a memory
holding system that can be powered
with a customer-installed
g-volt alkaline battery (not included). The power failure
protection circuit will not operate unless battery is installed.
When normal household power is interrupted, or AC line cord is unplugged, the
battery will power the clock radio to keep track of time and alarm settings
pro-
grammed into memory. When on battery power, the digital display will not light;
however, should WAKE TiME occur during the power interruption, the radio will
operate or the alarm will sound if remaining battery power is adequate. Normal
operation will resume after AC power is restored so you will not have to reset time
or alarm.
Install battery as follows:
1,
Remove battery compartment door (located on the back of the radio) by
applying thumb pressure to area indicated on battery door and then lift the door
out and off the cabinet.
2,
Connect a 9-volt battery to battery connector plug.
3.
Insert battery in compartment and replace compartment
door,
NOTE:
Alkaline
(NEDA 1604A)
batteries
are recommended.
Carbon-zinc
(NEDA 1604) batteries
may be used but memory
holding
time will be substan-
tially reduced.
Memory
holding
dine for a fresh alkaline
battery isapproxi-
mately
,_ hours
(if radio or alarm are not operated),
which
should
take care of
short,
nuisance-type
AC power failures.
To preserve
battery
life, the radio
should
remain plugged
into an AC outlet.
As batteries
get older,
their voltage
drops
and memory
may be lost. l_e sure to replace
the battery
periodically.
Battery should
be removed
if the radio
will be stored
for more
than one day.
Leaky batteries
can badly damage
the clock radio.
POWERFAILURE
INDICATOR
When AC power is interrupted (disconnected) for a short period both time and
alarm settings will change (unless optional battery is installed}. After A¢ power is
restored (reconnected) the Digital Display will blink to indicate that power was
interrupted and you must readjust the TIME and ALARM settings. To stop display
from blinking, press the HOUR or MIN button.
Ba_d _itda
Advertisement
