Page 1
SAVE FOR FUTURE REFERENCE OWNER'S MANUAL Model No. 415157030 Caution: Read and follow all Safety Statements, Assembly Instructions, and Use and Care NATURAL GAS GRILL Directions before attempting to assemble and cook. • Safety Rules Installer/assembler: Leave • Assembly Instructions these instructions with Use and Care consumer.
For your safety please read all the assembly instructions and use and care directions before proceeding with assembly or operation It is your responsibility to properly: FOR YOUR SAFETY . Assemble • Install 1. Do not store or use gasoline or other •...
Page 3
Installation of gdtl must conform with local codes, or in absence of local codes, with National Fuel Gas Code, Warnings, ........NFPA 541 ANSI Z223.1-1atestedition. Grill is not for use in or Introduction ............on recreational vehicles and/or boats. Warranty Information ..........if externa! electrical source is utilized with accessories (such as rotisserie), they must be electrically grounded in Table of Contents...
Page 4
Standard No. Item No. Description Part No. 1 ..Post assembly ...... I ..4504606 2 ..Bolt, 318"-!6 x 2-1t2"..4 ..4080677 3 ..Flat washer, 3/8" .... 4 ..4080641 4 ..Hex nut, 3/8L16 ....4080633 Gas supptytube ....
Page 6
OPTIONALBASE POST GROUND MOUNT In-ground mounting option for your new gril!° The accessory needed for this mounting option is available through the retailer where your grill was originally purchased, or by calling 1-800-241-8981 and ordering Model # 4989050, Base Post Assembly. Attaching Grill to Wood Deck Tip: Usethe PostAssemblybaseas a tempiate f ordrilling holesinto deck...
Page 7
Qty,2 Qty.2 (BEack) Qty,2 Qty,2 Support Tube Console Support Tube 4638003...
Page 8
A Do not cross-threadfitting. Wrench.tighten. Q_.2 Supply Tube. Console Grill Bottom_, Qty,2 Qty,2 A When installing Ignitor do not push on buttons This may cause a minor shock., Control Knobs A See Use and Care for Valve Check, ® " 4638003...
Page 9
Ibly _i, VERYIMPORTANT: uet Grate Burnertubes must pass through holes in grill bottomand engage valve attached to console. Holding Burner Assembly and Briquet Gratetogether, place into Grill Bottom Valve BurnerTubes must engage vatveon console Do not attach spring yet Drip VapoRISER Qty.1 Qty.1 Attach Electrodeto bottom of...
Page 10
Bent ends of brackets facing u Qty, 4 A Repeat for second side shetfassembly. (Silver) Qty,8 Maximum load for Side Shelf side shelves is 10 Ibs. Drip VapoRtSERBar Rest ignitor Round connector a_achesto ignitor beneath console Side Shelf Assembly...
Page 11
Logo Plate Heat Qty,2 Qty. 2 37(Turn Clockwise) Handle Qty,2 A Do not overtighten Nut or bend Bracket Qty.4 Qty.3 Qty,2 Qty.2 Swing Grid 4638003 •...
Page 12
Connecting Grill to Natural Gas Source ,4k Gas at line leading to grill mustbe shut off beforeconnectingto grill. A Attach gas supply tube to gas line. Wrenchtighten° _, The appliance and its individual shut off valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of t/2 psig (3oSkPa), A.
Page 13
Leak Test For your safety • Do not smoke during leak test. • Do not use an open flame to check for gas leaks • Grill must be feak checked outdoors in welF ventilated area, away from ignition sources such as gas fired or electrical appliances.
Page 14
Perform the "Burner Flame Check" in the Use and Care section. A Let grill cool before placing briquets. Place t6 briquets, Do not layer or stack just enough to cover fire grate surface A Do not let briquets cover burner port holes "...
Page 15
Safety Tips _k When grill is not in use, turn off all control knobs and gas source _k Never move grill whi!e in operation or still hot & Use Iong-handled barbecue utensils to avoid bums and For Safe Of Your Grill: splatters.
Page 16
Match Lighting General Grill Cleaning Do not lean over grill while • Do not mistake brown or black accumulation of grease and lighting, smoke for paint Interiors of gas grills are not painted at the Open lid, Turn on gas at gas factory (and should never be painted) Apply a strong solution source of detergent and water or use a gd!l cleaner with scrub brush...
Page 17
Cleaning The Burner Assembly Screw Follow these instructions to clean and/or replace parts of burner Collector assembly or if you have troubleignitinggdll Turn gas off at control knobs and gas source. Remove cooking grate and Drip VapoRISER Bar Discard briquets before removing burner and briquet grate Remove can from grease clip Beneath console disconnect short ignitor wire from ignitor(A)
Page 18
Cooking Chart Cooking times and temperatures may vary according to specific recipes, cooking conditions or barbecue equipment used Take these factors into consideration to insure best results If you use the indirect cooking method (indirect cooking is lightng only one burner and placing food on opposite side of cooking grate), allow more grilling time, Temperatures: High = 650 P I Medium = 450 F°...
Page 19
Food Safety Storing Your Grill • Food safety is a very important part of enjoying the outdoor • Clean cooking grates and discard old briquets. cooking experience, To keep food safe from harmflH • Store in dry location. bacteria, follow these four basic steps: •...
Page 20
n nn n nn i i i,,i i,i, ,u,ll,l,, Possible Cause PreventionlCure Probtem i , u, i, nll',,llll, iiiiii iiii Hill Cleanwireandlorelectrodewithrubbing a_coho! andcleanswab Wireand/orelectrode coveredwith Burner will not light cooking residue using ignitor. Electrodeandburnerarewet, Wipedrywithcloth Replace electrode Electrode crackedor broken"sparksat crack"...
Page 21
Sears, warrants to the original consumer-purchaser that this product shall be free from defects in workmanship and materials under normal and reasonable use and correct assem bly (if assembled by consumer-purchaser), as follows: (1) The aluminum top and bottom castings for the life of original purchase, excluding the paint finish; (2) The burner/venturi assembly for a period of three (3) years from the date of purchase;...
Page 22
For the repair or replacement parts you need delivered dJrectny to your home Call 7 am - 7 pm, 7 days a week t -800-366-PART (1-800-366-7278) For in-home major brand repair service Call 24 hours a day, 7 days a week 1-800-4-REPAIR (1-800-473-7247) For the location...