JVC GZ-MG680 Instructions Manual page 9

Howto usetheTouch Sensor
After the menu is displayed on the LCD monitor:
0
O Slide your finger up and down on the sensor.
OSelect [SET]. (Touch OK.)
O
_ITo select an on-screen button appearing on
the left side, touch the portion of the sensor
next to the on-screen button.
_ITo select an on-screen button appearing at
the bottom of the screen, touch the buttons
underneath them.
f
Read these INSTRUCTIONS
to enjoy your CAMCORDER.
For more details on the
operations, refer to the
GUIDEBOOK in the supplied
CD-ROM.
In order to view the GUIDEBOOK, Adobe ®
Acrobat ® Reader
TM
or Adobe ® Reader ¢
must be installed.
Adobe ® Reade® _ can be loaded from
Adobe's web site:
http://www.adobe.com/
Select your desired language with a single click.
The model name is indicated on the bottom of your
camcorder.
f
Read This First!
Make a backup of important recorded data
It is recommended to copy your important
recorded data to a DVD or other recording
media for storage. JVC will not be responsible
for any lost data.
Make a trial recording
Before the actual recording of important data,
make a trial recording and play back the
recorded data to check that the video and
sound have been recorded correctly.
Reset the camcorder if it does not operate
correctly
Close the LCD monitor and remove the
power supply (battery pack or AC adapter)
from the camcorder, then reattach it.
Precautions on handling batteries
• Be sure to use the JVC BN-VF808U/
VF815U/VF823U battery packs. This product
includes patented and other proprietary
technology and is made to be used with the
JVC battery and not with other batteries.
JVC cannot guarantee safety or
performance of this product when it is
operated by other batteries.
• If the camcorder is subjected to electrostatic
discharge, turn off the power before using it
again.
if a malfunction occurs, stop using the
camcorder immediately and contact
www.jvc.com or by phone at 1-800-252-5722
• Recorded data may be erased while the
camcorder is being repaired or inspected.
Back up all data before requesting repairs or
inspections.
Because camcorders may be used
for demonstration in a shop, the
demonstration mode is set to on by default
To deactivate the demonstration mode, set
[DEMO MODE] to [OFF].
E. 9