Advertisement
USING
THE
GENIUS
REMOTE
TO
CONTROL
CABLE
BOX
FUNCTIONS
(FOR
MODELS
27AX4S
and
27AX3B)
• To operate your cable box, point the Genius remote at the remote sensor of the cable box.
The Genius
remote
is designed
to operate
different
types of cable boxes.
You must firs: program
the Genius
remote
to
match the remote system
of your cable box
(Refer to Table 2 on page 31).
(1) Turn ON
your cable box.
(2) Set the Multi-Page
select switch
on the Genius
remote to MENU/CATV.
(3) AIM the Genius remote at the front of your cable box.
(4) While holding down the SELECT button, press the button that matches your cable box as shown on page 31. The
channels on the cable box will begin changing after 5 seconds when the correct button is pressed. When this happens the
Genius Remote control is programmed for your cable box. If the cable box channels do _lot change after 5 seconds, try a
different Genius Remote button.
(5) Release both buttons when the cable box begins to change channels. The precoded (:able box buttons will now control
your €'able box.
Notes:
• If your cable box cannot
be operated
after performing
the above procedure,
the codes have not been precoded
into
the Genius
remote control
and it will not be able to operate
your cable box.
• You will only have to program
your
remote
control
to match
your
cable box once.
The remote
will remember
the
codes
until you replace
the batteries.
• Whenever
you install or replace
batteries
in the Genius
remote,
you must reprogram
the Genius
remote
to match
the remote system
of your cable box.
• When
operating
your TV or VCR, remember
to set the Multi-Page
select switch
to the proper position.
• Be sure
to keep the original
remote
control
for the cable
box even
if you use the Hitachi
Genius
remote
to control
the cable box.
3O
Advertisement
