Reversing The Door - GE GTH18FBC2RWW Owner's Manual And Installation Instructions

Installation instructions
REVERSING THE DOOR
[-51REVERSING THE DOOR HANDLES (CONT.)
5.4 Transfer Freezer Door Handle
5.4.1 Remove the screw
holding the handle
to the top of the
door and die two
screws holding the
handle m die bottom
of the doon
5.4.2 Remove die handle.
5.4.3
Relnove
die screw from die
fig'llt mp edge of the door
and insert it into die handle
screw hole on die left side.
I .4.4 Transfer the door stop as shown in preceding i
section 5.2. ' I
5.4.5
Attach die handle to the rig'ht
edge of die door
widl screws at top and bottom,
using bottom holes vacated by
removal of the door stop
screws.
[-glRE-HANGING THE DOORS
6.1 R_hang the fresh food door
6.1.1 Lower the fresh flood door onto the
bottom hinge pin. Be sure the washer
is in place on the pin.
Plastic
Washer
SWING (CONT.)
[-gl RE-HANGING THE DOORS (CONT.)
6.1.2
Insert the pin on the center hing'e into the socket in the
top of the doon Place the space1; then the washe*; on die
hinge pin. Hinge Pin
NOTE: The center hinge must
be turned over as shown when
mounted on the left side.
Plastic Washer
and Spacer
6.1.3 Tilt the door toward the cabinet. As the door is brought
into position, slide the hinge under the head of the screw
which earlier had been partly d*_iven into the outermost
hole. Insert the remaining screxx_ then tighten both screws
securel}:
e¢-i
6.2 Re-hang the freezer door
6.2.1 Lower the freezer door _ _
onto the center hinge
pin. Be sure the
Center Hinge Pin \ "-"-_
washer and spacer
and Spacer
6.2.2 Tilt the door toward the cabinet, lifting the top hinge so
the pin fits into the socket on the top of the doon
6.2.3.
Make sure die door is slightly above the top of the
cabinet and the gap between the doors is even across the
front. Tighten the top hing'e screws. Do not overtighten
these screws tig'hten them until they are just snug', then
turn them anodler one-half turn.
14