Craftsman 171.926501 Owner's Manual page 14

ATrACHING THE SWITCH TO
THE TABLE (Fig. 5)
1. Insert two #10-32 x 21/2"button-head
machine screws (24) through the two
outermost holes on the front of the
switch. Slide a switch spacer onto
each screw, with the small end of the
spacers fitting into the hex-shaped
recesses on the switch. (Fig. 5).
2. Insert the two screws through the offset
holes in the front leg mounting rail,
keeping the spacers between the rail
and the back of the switch, and secure
in place with a #10-32 KEPS nut on
each screw.
Spacer
ATTACH THE FENCE (Fig. 6)
The fence for your router table comes
fully assembled with the adjustable
jointing fence and overhead guard
already in place.
1. Place the fence assembly on the router
table, aligning the slotted holes in the
fence with the holes on the router
table, as shown in Fig. 6.
2. On the left end of the fence as seen
from the rear, as in Fig. 6 (the end
WITHOUT the adjustable jcinting
fence), insert a 1/4-20 x 2" carriage
bolt (26) through the hole from the
bottom of the table.
3. Place a large washer (19) over the
end of the carriage bolt and thread a
clamping knob (9) onto the bolt. Do NOT
tighten completely at this time.
4. Repeat steps 2 and 3 on the right end
of the fence as shown in Fig. 6 (the end
WITH the adjustable jointing fence).
me clamping knob on this end will
also clamp the adjustable jointing
fence in place.
Figure 6
14