GE CV936 Owner's Manual & Installation Instructions page 17

Installation instructions
INSTALL MOTOR
• Align and engage tile
slots in tile blower
assembly to the 3 books
at the rear of the
exhaust
opening°
Motor Hook_
• Rotate motor upwards
r_-_
_1ooo oo i_
until it aligns with. th.e ,A_r_"_L
attacbmdK screw
location.
• Sectlre the illotoi to
attachment bracket
at the front of the
opening with washer
and screw provided. S__
//ylx_
the mating hood connector. See /!_i_ \ :
connector location. Touch the _
hood to locate and make tile /
/
COllllectioll. (_
IMPORTANT: Hold tile _x_ __L_f_
connector so tlle two square_'_J_ _--]--O_.L_
corner terminals are at tile top__ you \_-_ J
position tile connector to plug it in.
CONNECT ELECTRICAL
Verify that power is turned off at the source.
AWARNING"
[] Ifhouse wiring is not
2-wire with a ground wire, a ground must be provided
by the insmllm: When house wiring is aluminmn, be
sure to use U.L. approved
and-oxidant colnpound
and aluminmn-to-copper connectors.
/ -o .............. .__
A Remove C Insert Power ,_"_,
Junction Box ConduitThru i'a_(" ._,_
Cover Strain Relief '\ "%_"_t;_ I /,
andTighten _ ,,___.A..__y_
.... " .... . . _/
IIDi I II i_ ........... W hite
Ground--.._I I Z_.J /_glacl<
B Check That White, Blackand ['_/ff _ [
GreenHoodWires AreThreaded
It_/"!_,,,/'_g_ _ I
ThruSmall Holein Bracket _ J
D UseULListedWire Nuts
* Use wire nuts to connect incoming ground to green,
white to white and black to black.
e Push wires intojmlction box and replace cover.
Be sure wires are not pinched.
17
INSTALL DUCT COVERS
To install the 12 "duct cover alone:
* Place tlle 12" section of tlle decorative duct cover on
top of tlle hood.
e Secure tile cover to tile top of tile hood with 4 screws
provided.
To install the 2-piece duct cover:
* Place tlle 2-piece duct cover on top of tile hood.
* Secure tile bottom cover to the top of the hood with
4 screws provided. See illustration, page 16.
* Extend tlle inside section upwards to meet tlle
ceiling and ceiling bracket.
* Secure the duct cover to the bracket with the 2 small
Phillips screws provided.
INSTALL FILTER SUPPORT
* Tip filter support into tile rear of tile hood.
* Insert support robs into the slots at the rear of
tile hood.
/
/
¢
/
InsertTabsIntoSlots
/
* Secure the support to the hood with screws as shown.