GE CV936 Owner's Manual & Installation Instructions page 16

Installation instructions
iNSTALL CEiLiNG BRACKET
The ceiling bracket must be installed when the duct
cover is used to span 24" or more
height above the
hood. The bracket will hold the decorative duct cover
in place at the top.
Note: The ceiling bracket is not required when using
only the ]2" section of the duct cover.
* Install the 2 small screws into the sides of the duct
bracket. Remove the screws. Pre-tapping the boles
will insure ease of final installation.
* Match center notch on the bracket to the centerline
on the wall and flush against the ceiling.
* Mark the 2 screw hole locations.
* Drill 1/8" pilot boles in marked bracket location.
* If pilot boles do not enter studs, enlarge the boles to
3/8" and install wall fastener anchors.
* Secure the bracket to the rear wall with wood screws
and washers. Use wall anchors if needed.
Note: Bracket has 2 sets of holes. Use larger hobs for wall
fasteners or wood screws with washers. Usesmaller holes for
wood screws with washers.
Install
CeilingBracket _ ' i4! "-.
When Duct ,'"
Coveris
Usedto Span
24" or More
See Step 9
to Install
Duct Cover
CONNECT DUCTWORK
* Push duct over the end of the transition until it
reaches the stop tabs.
* Install ductwork, making connections in direction of
airflow as illustrated.
* Secure joints in ductwork with sheetmeml screws.
* Wrap all duct joints with duct rope for an airdght
seal.
* Use duct rope to seal the flange connection.
HouseDuctworl<
DuctTape
OverSeam
andScrew
DuctTape
Onlyfor Proper
Operation
of Damper /_//
f
DuctTape J
OverFlange
_Air
Flow
Screw
Ductworl<
Duct
Stops
\
sition
ACAUTION"
[] Do not use sheet
metal
screws at the transition to duct_,vork connection.
Doing so will prevent proper damper operations.
Seal connection with rope only.
16