Craftsman 486.24469 Operator's Manual page 5

STEP 2:
(SEE FIGURE 2)
* Assemble the latch stand bracket to the cart bed
using four 1/4 x 1" hex bolts and 1/4" nylock nuts.
Tighten.
FIGURE 2
LATCH STAND
BRACKET
I
1
I/4"NYLOCK
NUT
STEP 3:
(SEE FIGURE 3)
* Turn cart over and place tongue on latch stand
bracket and wheel support.
* Slide axle through wheel support and tongue.
J
TONGUE
AXLE
FIGURE 3
STEP 4:
(SEE FIGURE 4)
* Assemble the step bracket to the latch lock bracket
using two 5/16 x 3/4" hex bolts and 5/16" nylock nuts.
Tighten.
5/16 X 3/4"
HEX BOLT
\
f
LATCH LOCK --.-.. ;_
BRACKET
_ "" 5/16" NYLOCK NUT
\
STEP BRACKET
FIGURE 4
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
STEP 5:
(SEE FIGURE 5)
* Slide the step bracket and latch lock bracket into the
slot in the tongue.
* Secure the step bracket and latch lock bracket to the
tongue using a 5/16 x 4" hex bolt, a 5/16" sims nut on
each side of the brackets and a 5/16" nylock nut. Do
not over tighten, the bolt should pivot.
* Attach the short end of extension spring to the hole at
the bottom of the latch lock bracket.
* Using the spring puller tool, pull the long end of the
extension spring down and attach it to the tongue.
5/16" NYLOCK NUT
_EXTENSION SPRING
FIGURE 5
SPRING PULLER TOOL
STEP 6:
(SEE FIGURE 6)
• Assemble a spacer, a 1.59 x 1.032 x .06" washer, a
wheel (valve stem facing out), and then another 1.59
x 1.032 x .06" washer to the axle.
• Secure with a 1/8 x 1-1/2" cotter pin, spreading the
ends of the cotter pin with a pair of pliers bending the
ends around the axle.
• Press hub cap onto washer on outside of wheel.
• Repeat for other wheel.
1/8 X 1-1/2" 1.59 X 1.032 X
COTTER PiN .06" WASHER
\
• I_ _
SPACER
"_'HUB CAP
WHEEL
FIGURE 6