Craftsman 320.16490 Operator's Manual page 16

ROLLER OPERATION
When working on a long workpiece, the extension bars and rollers are needed.
The roller can be used as a stationary stop guide or a single directional roller.
• When using the roller as stop
guide, place the workpiece on
the plate; the roller assembly
works as an stop guide to cut
the workpieces to the length
required (Fig. 16).
When using the roller assembly
as a single roller, place the
workpiece on the roller for
convenient operation (Fig. 17).
I
Fig. 16 Stop guide
Steel plate
ADJUSTING THE EXTENSION
BARS (Fig. 18}
1. Extend the extension bar to the
required position to properly
support the workpiece.
2. Fully tighten the two
extension-bar
locking knobs (J).
Fig. 17
Fig. 18
A
Page 16 16490 ManuaLRevised_12 0604