Advertisement
STEP 6: (SEE FIGURE 6)
Assemble a wheel with the valve stem facing out
onto the axle. Assemble a hub cap (P) by pressing or
tapping it onto the axle. Repeat on other end of axle.
WHEEL
AXLE
\
(P) HUB CAP
FIGURE 6
FIGURE 7
(F) 5/16" × 3/4"
TRUSS HEAD
BOLT
(K) 5/16"
NYLOCK NUTS
LATCH
STAND
PLATE
LATCH STAND
BRACKET
STEP 7: (SEE FIGURE 7)
,
Turn the assembled tongue, wheel support and
wheels over to the upright position. Place the latch
stand bracket onto the tongue between the latch lock
assembly and the raised tab. Place the poly tray onto
the wheel support and latch stand bracket. Fasten
the tray to the wheel support using eight 5/16" x 3/4"
truss head bolts (F) and 5/16" nylock nuts (K). Do not
tighten
yet.
Place the latch stand plate between the latch stand
bracket and the poly tray.
STEP 8: (SEE FIGURE 8)
,
insert two 1/4" x 1o3/4" hex bolts (D) through the
handle tube as shown in figure 8. Holding the bolts in
place in the handle, insert the bolts through the holes
in the poly tray, al!owing the legs of the handle to slip
beneath the latch stand bracket. Secure the two bolts
with two 1/4" flat washers (I) and 1/4" nylock nuts (J).
Do not tighten yet.
(J} 114" NYLOCK
NUT
(l} 1/4" FLAT
WASHER
(D) 1/4" × 1-3/4"
HEX BOLT
LATCH STAND
BRACKET
FIGURE 8
Advertisement
