Safety First; Mounting - Nokia 610 User Manual

Safety first

The basic safety guidelines set out below are to be observed
x
when installing the car kit phone.
Make sure that the car ignition is off and disconnect the car
p
battery before beginning with the installation work and
ensure that it cannot be reconnected inadvertently.
Do not smoke when working on the car. Make sure that
p
there is no source of fire or flame nearby.
Take care not to cause damage to electrical cables, fuel or
p
brake lines or safety equipment during installation work.
Make sure not to impact the steering or braking systems or
p
other key systems essential for proper operation of the car
when installing car kit phone equipment. Check to make
sure that deployment of the airbag is not blocked or
impaired in any way.
RF signals may affect improperly installed or inadequately
p
shielded electronic systems in motor vehicles (e.g. electronic
fuel injection systems, electronic anti-skid braking systems,
electronic speed control systems, airbag systems). Should
you note a fault or change in the operation of such a
system, contact your car dealer.
The car kit phone may only be used at an operating voltage
p
of 12 V with the minus pole earthed. Failure to observe this
requirement may result in damage to the car's electronics
system.
Do not operate your car kit phone off the car battery for a
p
longer period of time, i.e. with the engine switched off, as
this may cause your battery to run dry.
In order to comply with RF exposure requirements for
p
mobile transmitting devices, a minimum separation
distance of 20 cm must be maintained between the antenna
and all persons.

Mounting

Nokia 610 car kit phone
Radio unit TFE-4 (Pos.1)
We recommend that you mount the radio unit TFE-4 at a less
visible position in the car interior. However, ensure that the unit
is installed to permit easy access to the SIM card so that it can
Copyright
Safety first
©
2004 Nokia. All rights reserved.
65