Nokia A032 Safety Information Manual page 6

WARNING!
Do not use the wireless LAN
card when the use of a
wireless LAN terminal is
prohibited or when it may
cause interference or danger.
Use only the region setting
appropriate for the area where
the wireless LAN Access Point
is used at the present time.
Using the Nokia A032 Wireless
LAN Access Point in any other
region or with an incorrect
region setting may be illegal.
Use only accessories approved
by Nokia for use with this
particular wireless LAN Access
Point. The use of any other
types may invalidate any
approval or warranty applying
to the wireless Access Point,
and may be dangerous.
For availability of approved
accessories, please check with
your dealer.
Install the Access Point close
to an accessible mains power
outlet.
4
Avoid installing the Access
Point near sources of heat or
in direct sunlight.
Disconnect the power before
relocating the unit. You can
only remove power to the
Access Point by physically
removing the power adapter
from the main outlet, or by
removing the low voltage
power jack from the rear of the
unit.
Only use the power adapter
that is supplied with the unit,
or a manufacturer approved
replacement. Use of any other
adapter could be unsafe and
cause damage to the Access
Point.
The Access Point is classified
as an SELV (Safety Extra Low
Voltage) circuit according to
European Standard EN 60950
(Safety of information
technology equipment). For
this classification to be
maintained, equipment to
which the unit is connected
must also be classified as
SELV.
Do not connect telephone
equipment or wiring to the
LAN port marked "10BaseT".
This socket is only for use with
RJ45 data connectors and the
ISO/IEC 8802-3 twisted-pair
Ethernet cabling system.
Nokia A032