Nokia A032 Safety Information Manual page 10

Wireless lan access point
Hide thumbs Also See for A032:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
CE, FCC & Industry Canada general interference statement
The Nokia A032 Wireless LAN Access
Points and Nokia C111 Wireless LAN
Cards comply with Part 15 of the FCC
rules, CE Low Voltage Directive 73/23/EEC
and CE EMC Directive 89/336/EEC.
Operation is subject to the following two
conditions:
This device may not cause harmful
interference.
This device must accept any
interference received, including
interference that may cause undesired
operation.
Note: The Nokia A032 Wireless LAN
Access Points and Nokia C111 Wireless
LAN Cards have been tested and found to
comply with the limits for a Class B digital
device and (in the case of Nokia C111
Wireless LAN Cards) a low power
transmitter, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
Reorient or relocate the receiving
antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an
output on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
8
The user must observe the following
precautions in installing and operating
this device:
Operate the equipment in strict
accordance with the manufacturer's
instructions for the model.
Plug the unit into a properly
grounded wall outlet and use the
(unmodified) power adapter supplied
with the unit.
Always operate the unit with the
factory installed cover on the unit.
Make no modification to the
equipment, which would affect its
meeting the specified limits of the
Rules.
Maintain the equipment in a
satisfactory state of repair.
Use a category 5 shielded 10BaseT
LAN cable and a shielded and
properly grounded serial cable to
ensure compliance of this unit to the
Class B limits of the Rules.
Nokia A032

Advertisement

Table of Contents
loading

Table of Contents