Enabling And Disabling The Failback Policy On An N_Port; Figure 12 Failback Behavior - HP StoreFabric SN6500B Administrator's Manual

3
Failback policy
Ports F_1 and F_2 are mapped to N_1 and continue routing to N_3. Ports F_3 and F_4, which were
originally mapped to N_2, are disabled and rerouted to N_2, and then enabled.
FIGURE 12

Enabling and disabling the Failback policy on an N_Port

Use the following steps to enable or disable the Failback policy on N_Ports.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag
3. Use the following commands to enable or disable the Failback policy:
56
Hosts
Host_1
F_1
Host_2
F_2
Host_3
F_3
Host_4
F_4
Host_5
F_5
Host_6
F_6
Host_7
F_7
Host_8
F_8
Failback behavior
failbackshow n_portnumber command to display the failback setting.
--
switch:admin> ag --failbackshow 13
Failback on N_Port 13 is not supported
•
Enter the ag failbackenable n_portnumber command to enable failback.
--
switch:admin> ag --failbackenable 13
Failback policy is enabled for port 13
Enter the ag --failbackdisable n_portnumber command to disable failback.
switch:admin> ag --failbackdisable 13
Failback policy is disabled for port 13
Example 3
Access Gateway
N_1
N_2
N_3
N_4
Fabric
Edge Switch
(Switch_A)
F_A1
F_A2
Edge Switch
(Switch_B)
F_B1
F_B2
Legend
Physical connection
Mapped online
Failover route online
Original mapped route
(offline)
Access Gateway Administrator's Guide
53-1002743-01