Disabling Unicast Storm Control; Configuring Jumbo Frames - Dell PS4000 Configuration Manual

The following commands shows how to configure Gigabit Ethernet interface 0/1 on switch 1 to auto-
negotiate the correct Flow Control setting with the device to which it is connected:
Switch> enable
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# flowcontrol receive desired
Switch(config-if)# exit
Switch(config)# exit
Switch# copy running-config startup-config
To view or confirm Flow Control status on a port, use the following command:
Switch# show flowcontrol interface gigabitethernet1/0/1
F.3 Disabling Unicast Storm Control
This section describes how to disable unicast storm control on Cisco Catalyst 3750 and 2970 switches.
The following example shows how to disable unicast storm control on Gigabit Ethernet interface 0/15
on switch 1 and verify the configuration:
Switch> enable
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/15
Switch(config-if)# no storm-control unicast level
Switch(config-if)# exit
Switch(config)# exit
Switch# copy running-config startup-config
To view or confirm storm control status on a port, use the following command:
Switch# show storm-control gigabitethernet1/0/15 unicast
F.4 Configuring Jumbo Frames
On Cisco Catalyst switches, MTU size cannot be set for an individual interface. Instead, it must be
configured for all Gigabit Ethernet ports on the switch, or for all ports in a VLAN. When the MTU size is
Dell EqualLogic Configuration Guide v11.3 63