32 MAINTENANCE
s Install theoildrain I_ug,
• Remove o il
gauge and refill with fresh oil (See
FUEL AND OIL RECOMMENDATIONS chapter).
• Cl'_ok the oil level (see PREPARATION chapter
for oil level check section).
r_ _I1_[_
Engine oil is a toxic substance. Dispose of
used oll properly. Contact your local author.
for approved disposal methods or pos-
sible recycling.
Oil Filter Change
* Change the oilfilterevery 200 houmof operaUon.
Hot engine oll can cause severe bums.
Allow engine temperature to drop _rom hot to
warm level before attempting to remove oil
filter.
* Drain engine oil intoa suitable container.
CAUTION
Before removing the oil filter, place suitable
pan under filter connection.
• Rotate the oilfilter(A) counterck_:Jw_4se
te remove
it.
• Coat e filmof clean engineoil on seal of newfilter.
• Installnew tilter rotatingit clockwise until seal con.
tacts mountingsurface (B). Then rotate liter 3/4
turn more by hand.
• Supply engine oil as specified.
• Run the engine for about 3 minutes, stopengine,
and check oil leakage aroundthe tilt_.
• Add o]1to compensatefor oil level drop due to oil
filler capacity (see PREPARATION chapterfor oil
level check section).
MAINTENANCE 33
A. Oil Filter
B. Mounting Surface
47
Need help?
Do you have a question about the RZT 50 and is the answer not in the manual?
Questions and answers
Remove choke control knob from cub cadet Rzt 50
Hello my question is this I have not a rzt 54 cyclo deck how can I bench test the pto with out removing it it was working fine for a while and then yesterday in mid mow it stopped and I haven't been able to find anything for fixing it