Sharp AR-PB2 Supplemental Manual page 19

N
PRINT NIC PAGE AT POWER ON (Network Settings menu)
If this function is set, the printer will print the NIC (Network Interface Card) configuration page when
power is turned on. This setting is enabled in the default setting.
N
PRINT PCL SYMBOL SET LIST (Print Test Page menu)
If this key is pressed, the printer will return to the online mode and print the PCL symbol set list.
Key operator program
The following key operator program is added.
Give Priority to Print Speed in Staple Mode
This program is used to select one of the two image processing methods for printing with stapling.
If this program is set, the printer will start printing while storing image data. The printing speed will
be higher. If improper paper size for stapling is found or the number of sheets exceeds the limit for
stapling, however, printing will stop. If this program is not set, the printer will start printing after
storing all image data. The printing speed will be lower. If an error data such as improper paper size
is received, however, the printer will continue printing without stapling. This program is set in the
factory default setting.
To give priority to printing speed, press the "GIVE PRIORITY TO PRINT SPEED IN STAPLE
MODE" box to display a check mark.
To cancel priority to printing speed, press the checked box again to clear the check mark.
NOTE This program can be applied to the AR-505.
19