Craftsman 486.241321 Owner's Manual page 8

10, Secure the bag corners over lower hopper tube
by snapping the flap to bag bottom on each sid_
See figure 18,
12, Locate h_fe along side of upper hopper tubes
and pierce a hole through the bag aiigned with
the hole in the tube, See figure 21,
FLAP
FIGURE 18
11.
Assemble the two hopper support rods as
shown in figures 19 and 20, Place top end of
rod into hole in uloper tube and bend rod
outwards and snap bottom end of rod into hole
in bottom tube. NOTE: Rods are spring steel and
require bending or bowing as shown, Do not
over bend and .lose bag support tension.
)RT ROD
FIGURE 21
i3.
UPPER HOPPER TUBE
S
Assemble mount clamps to each side of upper
hopper tube. Place one clevis pin through
clamps, hopper bag and hopper tube, then
secure clamps together with two 5/16" x 3/4"
hex botts and 5/16" lock nuts. See figure 22.
Tighten securely.
UPPER HOPPER
FIGURE 19
.... iii. i i i
FIGURE 20
SUPPORT RODS
FIGURE 22
14.
15.
'S PIN
Repeat step 13 for other side.
Assemble the bag retainers to clevis pins.
Secure with cotter pins. See figure 23. Wrap
cotter pin around clevis pin as shown in figure
23.
NOTE
Bag retainers must pivot freely.
8