Advertisement
STEP 6: (SEE FIGURE 6)
•
Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts (0), tooth lock
washers (J) (between the bar and bracket), 5f16" flat
washers (G) and knobs (N)The
boom connecting
hose should extend upward
NOTE:
Make sure the nozzles are adjusted so that the
openings face straight down when the boom bar is in the
horizontal operating position.
BOOM CONNECTINGwAsHER5/16
FLAT(G)HOSE
_-_._._
KNOB (N)
WASHER (J) "_
_
BOOM BAR
CARRIAGE BOLT
5/16" x 1-1/4" (C)
FIGURE 6
STEP 7: (SEE FIGURE 7)
•
Assemble the large (P) and small CO)spray gun clips
to the side of the tank using two #10 x 1/2" screws (D)
and #10 lock washers (I).
STEP 8: (SEE FIGURE 8)
Insert a garden hose gasket (T) into the swivel nut on
the bypass/return hose. Screw the nut onto the upper
outlet of the "Y" valve fitting Place the other end of
the hose down through the hole at the rear of the tank
•
Insert a garden
hose gasket
(T) into the swivel nut on
the boom connecting
hose
Screw the nut onto the
lower outlet
of the "Y" valve fitting
Slide the coiled hose clamp (S) onto the spray gun
hose. Push the hose onto the hose adapter on the
side of the "T" fitting as shown in figure 8. Tighten the
clamp around the hose and the adapter. Snap the
spray gun into the clips on the side of the tank
•
Carefully screw the pressure gauge (Q) into the top of
the "T" fitting.
BYPASS/RETURN
HOSE
SPRAY
GUN
COILED
HOSE
HOSE
CLAMP (B)
PRESSURE
GAUGE(Q)
BOOM CONNECTING
HOSE
FIGURE
8
#10LOCK
WASHER(I)
FIGURE
7
6
Advertisement
