Craftsman 14927 Operator's Manual page 3

7-'_.'_1 =I_N :] k'J
Items Needed:
Side (Qty:l)
Screw Leveler (Qty: 2)
Process:
• Ensure that the leveling screws on the existing
workbench are extended to at least (1.5) inch, (38 mm).
(See leveling foot adjustment.)
1.5"
(38 mm)
Items Needed:
Front Rail (Qty: 1)
1/4-20 x 5/8" Carriage Bolt (Qty: 10)
5/16" Washer (Qty: 10)
1/4-20 Serrated Flange Nut (Qty: 10)
NOTE: When installing on 8' workbench, remove inner
support rails before installing side.
Process:
NOTE: Drawer kit may be installed on left or right side.
Installation shown on right side.
• Install Side using (6) 1/4-20 x 5/8" Carriage Bolt, (6)
5/16" Washer, (6) 1/4-20 Serrated Flange Nut.
• Attach Front Rail, as shown, using (4) 1/4-20 x 5/8"
Carriage Bolt, (4) 5/16" Washer, and (4) 1/4-20 Serrated
Flange Nut.
• Finger tighten.
• Adjust bench to desired height. (See leveling
foot adjustment.)
Figure 1.1
Washer
\
\
\
Bolt \
,\
\
\
Nut
Side
• Assemble (2) Screw Levelers in Side. Make sure both
Levelers are fully retracted in Side.
Front Rail
Side
J
Figure 2
Figure 1.2