Assembling Steel Legs - Craftsman 113.206891 Owner's Manual

unpacking and checking contents
TABLE OF LOOSE PARTS
The Following Parts Are Included With
Models 113.206891 and 113,206932
Item
No. Description Qty.
A Leg ....................................... 4
B End Stiffener ............................... 2
C Side Stiffener .............................. 4
D Motor Support .............................. 1
E Motor ..................................... 1
Package of Miscellaneous Small Parts,
No, 67035, Consisting of the Following:
F Cord Clip .................................. 2
G Hex Nut, 1/4 in. -- 20
(approx. dia. of hole 1/4 in.) ................ 40
G HexNut, 5/16in.-- 18
(approx. dia. of hole 5116 in.) ................ 7
G Hex Nut, 1/2 in. -- 13
(approx. dia. of hole 1/2 in.) ................. 8
H Truss Hd. Screw, 1/4 in. -- 20 x 5/8 In.
long. (Top of screw is rounded) ............. 40
J Flat Washer (dia. of hole 11/32 in.) ............. 7
K Lockwasher, 1/4 in. External Type
(approx. dia. of hole 1/4 in.) ................ 40
K Lockwasher, 5/16 in+ External Type
(approx. dia. of hole 5/16 in.) ................ 7
L Carriage Bolt, 5/16 in. -- 18 x 3/4 long .......... 3
M Leveling Foot .............................. 4
N Hex Hd. Screw, 5/16 in. -- 18x 2 in............. 3
G
assembly
H
©
K
ASSEMBLING STEEL LEGS
NOTE: Steel legs are furnished with Model 113,206932
and 113.20689t.
From among the loose parts, find the following Hardware:
40 Truss Head Screws, 1/4-20 x 518
40 Lockwashers, !!4-External
40 Hex Nuts, 114-20
8 Hex Nuts, t/2-13
4 Leveling Feet
1. Assemble two (2) Side Stiffeners together using four
(4) 1/4-20 Truss head screws, Iockwasher and nuts.
Make two (2) Side Stiffener assemblies.
The End Stiffeners are placed on top and at each end
of Side Stiffener assemblies as shown. Align holes,
letter coded "B" (see page 8) in Side Stiffeners and
End Stiffeners and then insert 1/4-20 Truss head
screws through the 9/32 diameter holes and install
Iockwashers and nuts and then tighten.
2. Assemble the four (4) Legs to the Side and End
Stiffeners us/ng 1/4-20 screws, lockwashers and nuts
as shown.
3. Assemble the Motor Support to the Legs with 1/4-20
screws, Iockwashers and nuts. Motor Support can be
assembled to either end of Leg set.
4. Install leveling feet as shown. To level Leg Set, loosen
nut on inside of leg and turn nut on the outside to raise
or lower feet. Adjust all four leveling feet, if necessary,
and then tighten nuts on the inside of leg.
NOTE: These levelers are not intended for height
adjustment.
TRUSS HD. SCREW
1/4-20 x 5/8
L M N
END ST|FFENER
7