Craftsman 113.206891 Owner's Manual page 12

..... ..... your joi ............ : gettmg to know : nter-pianer
g--re:FENCE LOCKS AND STOPS. _The fence can be
moved across the J:ointer to take full advantage of
the "sharpness" of the blades.
The fence should be positioned to the extreme right
(toward pulley) but not beyond the end of the
blades.
Most of the cutting (usually jointing) will be done
with the fence in this position. As the blades become
dull, the fence can be moved toward the left where
the blades are sharper.
To move the fence, loosen the Fence Lock Knob and
the Sliding Guard Knob and slide to desi red position.
Make sure SLIDE BRACKET is even with surface of
OUTFEED TABLE. tf it is above or below the surface,
loosen screws and adjust it.
a. Always tighten fence lock knob first to align
fence, then tighten sliding guard knob.
b. Before tightening fence lock knob, hold fence
down on outfeed table so it does not rock.
C.
90 ° Fence Stop positions fence square to tables.
To tilt fence, loosen the fence lock knob and
sliding lock knob and pull the stop out, Tilt to
desired angle and tighten both knobs.
• d.
': e,
To set fence at 90 ° to tables, loosen the two
knobs, tilt fence so the stop springs back into
place. Tilt fence back so the stop rests on the
table and tighten both knobs.
45 ° Fence Stop positions the fence at 45 ° to the
tables.
SL,D,.G GUARD KNOB
PUSH DOWN _-_ __
WHEN LOCKING
/"OUTFEED
KNOB % _
: SLIDE BRACKET
: f. To tilt fence to 45 ° loosen the two knobs, pull 900
: .... stop out, tilt fence so the 45 ° stop rests on the ....
' ...... table.
....:.... g. Hold fence down on outfeed table and tighten the
: : : : =: two knobs. :
: : FENCE TILT SCALE Indicatesl the an:le oi the:: _il -"
fence to the tables. _/Vhen the 90 ° fenge stop is _: 9o ° FENCE _ _Q
correctly adjusted, the fence will be 90 ° to the table STOP t_ _1_ [
and the scale will read 90 ° , _
To check for squareness, place an accurate square
on infeed table and check fence while locked at 90 °
position. MAKE SURE 90 ° STOP IS AGAINST SLIDE
BRACKET.
tf fence is not square to table:
a. Slightly loosen fence lock knob and guard lock
knob.
__.-- FENCE TI LT SCALE
INFEED
TABLE
12