Location And Function Of Controls - Craftsman 113.232210 Owner's Manual

90° AND 45 °
FENCE STOPS _
FENCETI_ 7
SCALE
5 SLIDING GUARD
KNOB
1 DEPTH OF CUT
HANDWHEEL
_: :i _ ::!!: ::;: i
4 FENCELOCK
KNOB : _
LOCATION AND FUNCTION OFCONTROLS
1. Depth of cut handwheeh i: : _ _:
By,turning the handwheel you can controihow much
wood will be removed from the workpiece.
2. On-Off Switch_ _:
Turns the tool on and off.
3. Cutter Guard:
Helps protect the operator from the sharp knives on
the cutterhead,. It is spring loaded so it automat-
ically keeps the cutterhead covered before, during,
and after a cutting operation,.. It must always be
used, :
4. Fence Lock Knob:
Allows the fence to be: repositioned and locked at
any angle from 45 ° to 90 °. To lock--turn the knob
clockwise:. To unlock--turn the knob counter-
clockwise.
2 ON-OFF
SWITCH
3 CUTTER
GUARD
5. Sliding Guard Knob:
Allows the fence to be repositioned at any location
from the front to the rear of the tables and to
be locked at that position. To unlock--turn the knob
counterclockwise.To lock--turn the knob clockwise,
6. 90° and 45 ° Fence Stops:
When adjusted properly, these stops provide a
method for quickly moving the fence to a 90 ° or 45 °
position from the table,
7, Fence Tilt Scale:
Helps the operator accurately and quickly position
the fence at any angle between 45" and 90 °.
11