5.
To place the new belt begin by routing
the belt around the
two outer spindle
pulleys as shown in Fig. 7-8.
10.
Pull the right side of the belt and place the narrowV
side of
the belt into the PTO pulley. See Fig. 7-9.
F
Figure 7-8
6.
Then route the belt around
the two deck idler pulleys as
show in Fig. 7-8.
7.
Reinstall the belt keeper rod loosened
earlier.
CAUTION:
Failure to reinstall the belt keeper rod
may result in serious damage
to your tractor's
PTO
system.
8.
Remount
the belt guards removed
earlier.
9.
Re-install
the deck making
sure the belt remains routed
around the pulleys as instructed.
J
11.
Figure 7-g
While holding
the belt and pulley together,
rotate the
pulley to the left (See Fig. 7-9). Continue
holding
and
rotating
the pulley and belt until the belt is fully rolled into
the PTO pulley.
SECTION 7--
SERVICE