Chapter 3 Using The Features; Basic Operation - Hitachi L19D01UB Instruction Manual

Chapter 3 Using The Features

BASIC OPERATION

Tuning in the TV channels
After connecting an aerial to your LCD TV and connecting the mains cable to the TV
and 100-240V AC mains socket, turn the POWER SWITCH on (the | position) at the
rear panel of the TV, and the red light will show on the front centre panel of the TV.
Press the STANDBY
Installation screen will show:
MENU Audio Setup Auto installation PN "0000" Country select Start Search OK
1. Make sure an aerial is fitted then press MENU button on the remote to start the "Auto
Installation". (The default PIN is "0000")
2. After a few minutes, you will see the TV programs briefly as each channel is received and
stored in the memory.
To power off press the STANDBY
Selecting a Source
Press the INPUT button to display the function required ( TV/SCART/AV(YPbPr)/HDMI1/HDMI2/VGA ).
Select TV Channel
Press the CH. buttons on the remote control or the
TV channels.
You can directly select the TV channel required by pressing 1, 2, or 3 etc on the remote
button pad.
Adjusting the Volume
+ -
/
Press the VOL. buttons on the remote control or the
the volume.
Note
Adjust the volume level to its minimum first, and then slowly increase the volume to your desired level.
22
button, and the red light will change to blue and the
button, the blue light will change back to red.
buttons on the LCD TV to
/ buttons on the LCD TV to adjust
ON FF
LHD01
change the
.