Starting The Setup Program - Epson Progression 4 Setup Manual

Cache, cache testing, and non-cacheable address operation
for the internal cache.
The configuration you define through SETUP is stored in a
special area of memory called CMOS RAM. This memory is
backed up by a battery, so it is not erased when you turn off or
reset the computer. Whenever you reboot the computer, it
checks the settings, and if it discovers a difference between the
information in the CMOS RAM and its actual hardware
configuration, it prompts you to run SETUP. You see a message
such as the following:
M e m o r y s i z e
P r e s s < F 2 >
message to press [nl to resume.)

Starting the SETUP Program

To start SETUP, turn on your computer. As soon as you see the
following prompt, press m
Note
If you do not press [Ft) within five seconds, the computer
tries to load the operating system and you will not be able to
run SETUP 2. If this happens, turn off the computer wait 10
seconds, then turn it back on to try again.
2-2 Running the SETUP Program
mismatch
to run
S E T U P
to