Starting The Setup Program - Epson Equity IIe User Manual

Starting the Setup Program

Follow these steps to start the Setup program:
1. Insert the Reference diskette into drive A. If you have a
5 '/+inch diskette drive, turn the latch down (clockwise) to
lock the diskette into place. If you have a 3 '/z-inch diskette
drive, slide the diskette into the drive until it clicks into
place. (For more instructions on inserting and removing
diskettes, see Chapter 3.)
Note
Be sure to make a backup copy of your Reference diskette
after you run the Setup program and install MS-DOS.
See Chapter 3 for instructions on how to copy diskettes.
2. Turn on your system. (Remember to turn on your monitor
and any peripherals before you turn on the computer.) The
screen displays the Operation Menu:
OPERATION
1 - Setup
2 - Format hard disk
3 - System diagnostics
4 - Prepare hard disk for moving
0 - Exit to DOS for more utilities
If an error message appears when you turn on the
computer, see "Continuing From an Error Message,"
below.
2-2 Running the Setup Program
MENU