Sequential Repair Service Program Feature; Feature; Printhead Removal - Epson Stylus COLOR 880 Service Manual

EPSON Stylus COLOR 880
Figure 5-11. Destination Setting
NOTE: This program runs under the IEEE 1284 Nibble mode, not the D4 mode.
Therefore, if an error occurs on the printer, this program can not be used.
Calling Data are stored in the specific address of the E
CG table: PC487
Font: Courier
Parallel IF: Auto
Top Margin: Bottom Margin, Page Length
4) Select the Program type which you will run in the menu.
Figure 5-12. Program type selection
Adjustment
5.3 Sequential Repair Service Program

feature

5.3.1 Feature
In this manual, we will explain mainly about the Sequential repair service
program.
This program provides you the suitable adjustment order by selecting the
repair item in the Sequential repair service program main menu. In this
program, following 7 items are listed.

Printhead removal

Printhead replacement
Main board replacement
CR unit replacement or removal
CR motor replacement or removal
2
PROM.
Printer mechanism replacement
Waste Ink Pad replacement

Sequential Repair Service Program feature

Revision A
127