Related Manuals for Cardo Systems Scala rider Q2
Summary of Contents for Cardo Systems Scala rider Q2
-
Page 1: User Guide
™ ™ ™ communication in motion Gebrauchsanleitung Guide d’Utilisation Guida di Avvio Guia de Usario User Guide... - Page 2 © Cardo Systems, Inc. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Cardo Systems, Inc. is under license. Other trademarks and trade names are those of their respective owners.
- Page 3 INTRODUCTION CONTENTS OF RETAIL BOX Congratulations, and thank you for choosing the scala rider Q2 Bluetooth® Headset for bikers. This Manual will help you operate the Volume Headset headset, but you should first familiarize yourself with the Bluetooth functionality of your cellular phone and/or GPS device before using Charging the scala rider Q2.
- Page 4 SET UP AND CONFIGURATION Wall Charger Allen Wrench Velcro Pads MP3 Cable Built-in FM radio Mobile phone MP3 Cable Holder player Glue Plate Driver-to-Passenger Full-duplex Pre-moistened Towelette Intercom Connection Carry-Pouch Bike-to-Bike Intercom Microphone Sponges up to 500 m / 540 yd scala rider Q2 or other (in open terrain) scala rider headset...
- Page 5 NOTE: The scala rider Q2 allows you to speak via Intercom to one STEP 2 (Optional) Buddy headset at a time. SET UP FOR RIDER-TO-PASSENGER INTERCOM: PAIRING PRIMARY BUDDY PAIRING (requires two scala There are two ways that the scala rider Q2 can be used for Driver-to- rider Q2 headsets) Passenger communication.
- Page 6 1. Place the scala rider Q2 into Intercom Pairing mode following the phone’s instructions. Please consult your phone’s User Manual instructions in the PRIMARY BUDDY PAIRING section above. for more information. 4. After a few seconds the phone will list the scala-rider Q2 2.
- Page 7 3. Search for Bluetooth headsets on your GPS device by following 2. Slide the Back Plate between the internal the device’s instructions. Please consult your GPS device’s User padding and the external shell of the helmet. Manual for more information. 3.
- Page 8 microphone must be positioned vertically and not horizontally (Be POSITIONING THE SPEAKERS sure to clean the selected area prior to the gluing process). 4. Use the pre-moistened Towelette to clean the helmet area where Attach the speakers to the Velcro inside you want to install the Glue Plate.
- Page 9 REMOVING: A high priority Audio Source will always interrupt any lower priority Press here Audio Source. to remove Your headset can be removed for charging i.e. Mobile phone call interrupts Intercom call and storage by pressing your finger Intercom call interrupts FM Radio gently against the tab and sliding the headset up with the other hand.
- Page 10 Reconnecting the Intercom: If the scala rider Q2 and its Intercom • One beep – Voice Connect set to Primary Buddy Buddy headset go out of range and disconnect from each other, the • Two beeps – Voice Connect set to Secondary Buddy scala rider Q2 will automatically try to reconnect to its Intercom Enable/Disable Voice Connect feature Buddy for five minutes.
- Page 11 Once the phone call audio link drops, you can initiate and accept call), press and hold the MC Button on your headset for three seconds Buddy Intercom calls. to turn on the radio. The radio tunes in to the last radio station you were listening to.
- Page 12 If you don't save the station, the Radio will exit search mode without Make sure that the cable plug clicks into place. saving the current station. You can still continue to listen to the 7. Tuck the MP3 cable into the hook of the MP3 cable holder. current unsaved station.
-
Page 13: Waiver And General Release
(jointly referred installation. This equipment generates, uses and can radiate radio frequency to as “Vehicle”) requires your complete and undivided attention. Cardo Systems, Inc., energy and, if not installed and used in accordance with the instructions, may cause including its Officers, Directors, Affiliates, Parent Company, Representatives, Agents, harmful interference to radio communications. - Page 14 its technical capabilities and should not be misconstrued as if encouraging users to causes. You hereby assume all risks and dangers and all responsibility for any losses operate the Device while actively involved in traffic. and/or damages, whether caused in whole or in part by the negligence or other conduct of others, including the Company.
Need help?
Do you have a question about the Scala rider Q2 and is the answer not in the manual?
Questions and answers