Electrolux Z430 Series Owner's Manual

Electrolux upright vacuum cleaner owner's guide

Advertisement

Quick Links

Upright Vacuum Cleaner

Owner's Guide
Household Type
Z430 Series
IMPORTANT
For any advice
on your cleaner and
to order filters and
accessories,
please telephone the
Electrolux Helpline on
08706 055055
2 - 3
IMPORTANT INFORMATION
4
GUARANTEE
5
QUICK REFERENCE
5
HOW TO ASSEMBLE
6
HOW TO USE
7
ROUTINE MAINTENANCE
7
Empty Dust Cup
8
Clean Dust Cup Filter
9 - 11
PROBLEM SOLVING
9
Remove a Clog
Brushroll Circuit Protector
9
FILTER REPLACEMENT CODE: EF89
www.electrolux.co.uk

Advertisement

Table of Contents
loading

Summary of Contents for Electrolux Z430 Series

  • Page 1: Upright Vacuum Cleaner

    Upright Vacuum Cleaner Owner’s Guide Household Type Z430 Series IMPORTANT For any advice on your cleaner and to order filters and accessories, please telephone the Electrolux Helpline on 08706 055055 2 - 3 IMPORTANT INFORMATION GUARANTEE QUICK REFERENCE HOW TO ASSEMBLE...
  • Page 2: Important Safeguards

    • Use only as described in this manual. Use only manufacturer’s recommended attachments. • Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using.
  • Page 3: Before You Start

    13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug.
  • Page 4 The guarantee may be invalidated by unauthorised repair or modification of the appliance. d. You may be charged by Electrolux if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet. (example: blocked/dirty filters) Electrolux does not accept liability for all defects arising from neglect, misuse or accident.This guarantee excludes...
  • Page 5: Quick Reference

    QUICK REFERENCE HOW TO ASSEMBLE Assemble completely before using. 1. Attaching or Removing Floor Nozzle. Align the lock button on the floor nozzle neck with the hole in the receiving tube on the main body. Push the lock button and slide the floor nozzle into the main body until it clicks into place.
  • Page 6: How To Use

    HOW TO USE Power Switch 1. This vacuum has a 3-position switch. O is Off, I is “Suction Only,” and II is “Suction and Brushroll.” 2. For bare floor cleaning use suction only (I). For carpet cleaning, use suction and brushroll (II). The nozzle allows for low profile cleaning.
  • Page 7: Routine Maintenance

    ROUTINE MAINTENANCE The instructions in this booklet serve as a guide to routine maintenance.To keep the cleaner operating at top efficiency empty the dust cup and clean the filter after each use. To maximize cleaner efficiency do not allow the dust cup to be filled past the bottom of the filter.
  • Page 8 NOTE: When vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances, the dust cup filter will require more frequent maintenance. NOTE: U s e o n l y G E N U I N E ELECTROLUX replacement filters, Code EF89.
  • Page 9: Problem Solving

    PROBLEM SOLVING Remove a Clog in the Base This model has a clean-out port which allows access into the bottom of the power nozzle in order to remove large debris that has become lodged in the airway. CAUTION: Turn off the power switch and unplug the electrical cord to service.
  • Page 12 Vacuum Cleaner Nozzle Thank you for purchasing an Electrolux cleaner. Don’t Forget to Use Genuine Electrolux parts Caution: Damages caused by the use of non-genuine parts are not covered by the Electrolux Guarantee. Part No. 75585A (11/05) Printed in PRC...

Table of Contents