Configuring Hybrid REAP
switchport mode trunk
spanning-tree portfast
!
interface Vlan100
ip address 10.10.100.1 255.255.255.0
ip helper-address 10.10.100.1
!
interface Vlan101
ip address 10.10.101.1 255.255.255.0
ip helper-address 10.10.101.1
end
Configuring the Controller for Hybrid REAP
This section provides instructions for configuring the controller for hybrid REAP using either the GUI
or the CLI.
Using the GUI to Configure the Controller for Hybrid REAP
The controller configuration for hybrid REAP consists of creating centrally switched and locally
switched WLANs. Follow the steps in this section to use the GUI to configure the controller for these
WLANs. This procedure uses these three WLANs as examples:
WLAN
employee
employee-local
guest-central
See the
Note
would prefer to configure the controller for hybrid REAP using the CLI.
Follow these steps to create a centrally switched WLAN. In our example, this is the first WLAN
Step 1
(employee).
a.
b.
Cisco Wireless LAN Controller Configuration Guide
12-6
Security
WPA1+WPA2
WPA1+WPA2 (PSK) Local
Web authentication
"Using the CLI to Configure the Controller for Hybrid REAP" section on page 12-12
Click WLANs to access the WLANs page.
Click Next to access the WLANs > New page (see
Chapter 12
Configuring Hybrid REAPWireless Device Access
Switching
Interface Mapping (VLAN)
Central
management (centrally switched
VLAN)
101 (locally switched VLAN)
Central
management (centrally switched
VLAN)
Figure
12-2).
if you
OL-9141-03