Bogen TPU100B Installation And Use Manual
Telephone paging amplifier
Hide thumbs
Also See for TPU100B:
- Information (13 pages) ,
- Installation & operating instruction (6 pages) ,
- Installation & operating instructions manual (6 pages)
Related Manuals for Bogen TPU100B
Summary of Contents for Bogen TPU100B
- Page 1 Telephone Paging Amplifier Models TPU35B, TPU60B, TPU100B, TPU250 Installation and Use Manual © 2005 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice. 54-5900-01D 1101...
- Page 2 NOTICE: Every effort was made to ensure that the information in this guide was complete and accurate at the time of printing. However, information is subject to change. WARNING: To reduce the risk of Fire or Electric Shock, Do Not Expose this apparatus to rain or moisture.
-
Page 3: Table Of Contents
Contents INTRODUCTION ....................4 PACKAGE CONTENTS ..................4 INSTALLATION ....................5 Mounting Ventilation Wall Mounting Rack Mounting the TPU35B, TPU60B, & TPU100B Rack Mounting the TPU250 INPUT WIRING CONNECTIONS ..............6-7 Music Input Microphone Input TEL Input Night Ringer Connection Bridging Inputs Input Cover Replacement OUTPUT WIRING CONNECTIONS ..............8 Speaker Connection Line-Matching Transformer WMT1A Connector... -
Page 4: Introduction
Figure 1a: TPU250 Telephone Paging Amplifier Telephone Paging Amplifier Introduction This document describes the Bogen TPU35B, TPU60B, TPU100B (See Fig.1) and TPU250 (see Fig.1A) Telephone Paging Amplifiers. They are full-featured, wall-mounted amplifiers that provide inputs for dry-loop, 600-ohm telephone page signal, background music source, and low impedance microphone. -
Page 5: Installation
Installation Figure 3: Rack Mounting the TPU250. Figure 2: Wall Mounting the Amplifier See NOTE below for information on alternate orientation. Screw #8 x 5/8” (M4 x 16mm) with Screw #8 x 5/8 “ (M4 x 16 mm) with Rack Mounting Screws Synthetic washer 1/8”... -
Page 6: Input Wiring Connections
The music input is a mono unbalanced input, so the music sourceʼs output should be unbalanced and mono. If a balanced input is needed, use a Bogen Line-Matching Transformer WMT1A (sold separately) to balance the music input. The WMT1A is also effective in breaking ground loops that cause hum. -
Page 7: Night Ringer Connection
Input Wiring Connections Night Ringer Connection Either a standard telephone (analog) ring signal (90 – 105V AC, 20 – 30 Hz) or an external contact closure activates the night ringer function of the amplifier. To activate the night ringer using standard telephone (analog) ring, connect the analog station's tip lead to the TEL RING "T"... -
Page 8: Output Wiring Connections
Output Wiring Connections All output wiring connections are made to the terminal strip located under the right side access panel. Loosen the two Phillips-head screws on each side of the cover and remove the cover. IMPORTANT: Before making any connections or wiring changes to the amplifier or any equipment connected to the amplifier, make sure that the amplifier is NOT plugged into an AC outlet. -
Page 9: Operation
Operation Indicator LEDs The POWER LED illuminates whenever AC power is applied to the amplifier (there is no power switch on the amplifier). POWER The PEAK LEVEL LED illuminates whenever the speaker output signal level approaches its maximum level. This indicator is used when setting PEAK LEVEL volume levels. - Page 10 Operation RINGER VOLUME adjusts the level of the night ringer tone output. The RINGER VOLUME music volume level should first be set to the customer's satisfaction. When adjusting this level, the PEAK LEVEL indicator should be used to ensure that the amplifier signal is not distorted. MUSIC MUTE adjusts the level of the background music heard during a MUSIC MUTE paging announcement.
-
Page 11: Specifications
Specifications Technical Specifications Power Output: TPU35B: 35W RMS; TPU60B: 60W RMS; TPU100B: 100W RMS; TPU250: 250W RMS Frequency Response: 70 Hz to 15k Hz ±1 dB Distortion: Less than 1% Hum & Noise: (20 Hz to 20 kHz) MUSIC: -70 dB; TEL: -70 dB; MIC: -55 dB Sensitivity: MUSIC: 85mV;... -
Page 12: Limited Warranty; Exclusion Of Certain Damages
State to State. Products that are out of warranty will also be repaired by the Bogen Factory Service Department – same address as above or call 201-934-8500.
Need help?
Do you have a question about the TPU100B and is the answer not in the manual?
Questions and answers