Troubleshooting Guide - Canon EOS 1D MkII Instruction Manual

Troubleshooting Guide

If there is a problem, first refer to this Troubleshooting Guide.
Power Source
The battery cannot be recharged.
You are using the wrong battery.
¡
Use the dedicated Ni-MH Pack. (p.18)
s
The battery is not properly attached to the charger.
¡
Attach the battery properly to the charger. (p.18)
s
The camera does not operate even when the < 4 > switch is set to < 1 >.
The battery is exhausted.
¡
Recharge the battery. (p.18)
s
The battery is not installed properly.
¡
Install the battery properly. (p.20)
s
The memory card slot is open.
¡
Push in the memory card and close the memory card slot. (p.24)
s
The access lamp lights or blinks even when the < 4 > switch is set to < 2 >.
If you set the <
¡
access lamp will still light or blink for a few seconds while the
image is recorded onto the memory card.
When the camera finishes recording the image to the memory
s
card, the access lamp will stop blinking and the power will turn off.
The battery becomes exhausted quickly.
The battery is not fully charged.
¡
Recharge the battery fully. (p.18)
s
The battery's service life has expired.
¡
Replace it with a new battery. (p.168)
s
162
> switch to <
4
> right after shooting, the
2