Table of Contents
Advertisement
BEFORE YOU CALL FOR SERVICE
If the unit appears to be malfunctioning, read through Normal Operation first. If the
problem persists, check the Troubleshooting Guide. Locate the problem in the
guide and refer to the cause and its remedy before calling for service. The problem
could be something very simple which can be solved without a service call.
TROUBLESHOOTING GUIDE
D D D D D ANGER
ANGER
ANGER
ANGER
ANGER
!
ELECTROCUTION HAZARD
NEVER attempt to repair or perform maintenance on the unit until the main electrical
power has been disconnected.
Troubleshooting – What to check when problems
occur
Problem
Unit does not operate.
Unit runs but no ice is produced.
Unit runs but produces very little ice. • Dirty condenser coils.
Ice is slow to release or does not
release from the evaporator.
Troubleshooting
Possible Cause
Remedy
• No electrical power to the unit.
• Make sure power cord is plugged in. Check for
• Cycle selector switch set
• Make sure cycle selector switch is set to ICE/ON.
improperly.
• Surrounding air temperature must be at least
• Low air temperature around unit.
• No water being supplied to the
• Check to see that water is connected and turned
unit.
• Clean the condenser. See Maintenance.
• High air temperature around unit.
• Surrounding air temperature of over 90°F (32°C).
• Scale and mineral buildup in unit.
• Clean unit. See Maintenance.
• Inadequate airflow at the front of
• Remove items blocking airflow.
the unit.
• Ice-making system is dirty.
• Run unit through automatic clean cycle. See
• Unit is not level.
• See Leveling the Unit.
• Low air temperature around the unit.
• Surrounding air temperature must be at least 50°F
blown fuse or tripped circuit breaker.
45°F (7°C).
on to the unit.
Low ice production at high temperatures is
normal.
Maintenance.
(10°C).
31
Advertisement
Table of Contents
