Chapter 7
Troubleshooting the CTS 1300
Figure 7-55
Zoom ring
Step 5
Adjust the camera mounting plate to center the red plus sign on the display inside the black plus sign on
the target.
The screws that you use to adjust the camera are shown in
•
The top two screws provide adjustment to the right and left. Use a 2.5 mm Allen wrench for these
screws.
•
The lower screw provides up and down adjustment. Use a 2.5 mm Allen wrench for this screw.
•
The screws in the middle adjust the camera rotation. Use a 3 mm Allen wrench for these screws.
OL-13676-04
Location of Focus and Zoom Ring
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Focus ring
Figure
7-56.
7-59