Cps Programming Setup; Cloning (Conventional And Ltr); Figure 5-2: Cps Programming Setup - Motorola HT750 - UHF/VHF/Low Band - Radio Service Manual

Radio Tuning, Programming, Cloning, Lowband Antenna Cutting Procedure, PassPort Tone Options, and Diagnostic Functions
5.3

CPS Programming Setup

The CPS programming setup, shown in Figure 5-2, is used to program the radio codeplug.
NOTE: Refer to appropriate program on-line help files for the codeplug programming procedures.
Radio
Battery
Block
0180305G54
Battery
Eliminator
7.5V Reg.
RLN4510
+12VDC
Power
Supply
5.4

Cloning (Conventional and LTR)

Cloning is the same for both the Conventional and LTR radio. Cloning is the process of copying the
content of one radio (source radio) into another radio (target radio). Radio content refers to system-
type features such as frequency, squelch type options, trunking, etc.
NOTE: Cloning can be performed only on radios with identical model numbers and software options.
Radio functionality inherent in one radio cannot be cloned to another radio that does not contain the
same functionality. Tuning and alignment information are not transferable and are not affected by
cloning.
Signaling Identification Numbers (IDs) are duplicated in the cloning process. Unique IDs may be
assigned with the CPS.
NOTE: Unsuccessful cloning attempts will not damage the radio.
Procedure:
1. Turn source and target radios off.
2. Connect cloning cable to side connector of both radios.
3. Turn on target radio.
4. On source radio, simultaneously press 'side buttons 1 and 2', shown in Figure 5-3, then turn radio
on. Both radios produce a "clone-entry" tone and turn on their green LEDs. Display radios show
"Cloning To" (source radio) and "Program" (target radio).
5. Release both side buttons. The electronic transfer process begins and will take approximately
one to three minutes.
6. When cloning is completed, both radios reset themselves and turn their green LEDs off. The
Test Box
RLN4460A or B
Program/
Test Cable
AARKN 4074
NOTE: Ribless Programming Cable
is part number RKN4075
RIB
RLN-4008
RIB Power Supply
120/230 Vac

Figure 5-2: CPS Programming Setup

DB9 Tx Data
DB15
Rx
Data
Gnd
Computer Interface
Cable
3080369B72
5-3