Remote In Terminal - Panasonic PT-DW530E Operating Instructions Manual

Technical Information

REMOTE IN terminal

Using the [REMOTE IN] terminal provided on the connection terminals of the main unit, it is possible to operate
the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot
be received.
Projector set up in a meeting room
Pin assignments and control
J
D-Sub 9-pin (Outside view)
Attention
Be sure to short-circuit Pins
z
When pin and pin
z
cannot be used.
<POWER ( )> button, <AV MUTE> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
When pin and pin
z
on the projector's control panel and on the remote control cannot be used.
<POWER ( )> button, <INPUT SELECT> buttons (RGB1, RGB2, DVI-D, VIDEO/S-VIDEO, NETWORK, HDMI),
<AV MUTE> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
The above is explanation in the case where
z
"STANDARD".
86
- ENGLISH
Pin No.
and when controlling.
are short-circuited, the following buttons on the projector's control panel and on the remote control
are short-circuited and then any one of pins
"REMOTE MODE" of "PROJECTOR SETUP" (
Remote control
Remote control/External control
RGB1
RGB2
DVI-D
Control panel located in a different room
Signal name Open (H)
GND
POWER OFF
RGB1 Other
RGB2 Other
VIDEO Other
S-VIDEO Other
DVI-D Other
AV MUTE OFF
Controlled by
RST/SET
remote control
to is short-circuited to pin
External control
Standby ON
LAMP
VIDEO
S-VIDEO
Short (L)
— GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI-D
ON
Controlled by
external contact
, the following buttons
Æ page 67) is set to