HP D7171A - NetServer - LPr Installation Manual page 32

Chapter 3
CAUTION No low level format is needed. HP performs the low-level
format at the factory.
Initialize the file system, using the operating system format utility.
NOTE
If you are experiencing problems with the drive, watch the
messages on your monitor while the system boots. A message
appears if a drive is not recognized by the HP NetServer (which
happens when the HP NetServer attempts to communicate with
a drive before the drive has finished spinning up).
If the system did not recognize a hard drive:
Do not power-down (power-cycle) the system to restart it, as
this causes all the drives to stop spinning.
28
Mount the Drive in the NetServer E 45
Wait until all drives reach full speed.
Press the Reset button on the system or press the
Ctrl+Alt+Del hot-key combination to restart the HP
NetServer without powering it down.