HP D7171A - NetServer - LPr Installation Manual page 28

Chapter 3
Power
System Board
Switch
IDE1
IDE2
Flexible Disk
Controller
Flexible Disk
Shelf 1
CD-ROM Shelf 2
Shelf 3
Shelf 4
For cabling options and connector locations, see the
Technical Reference Label inside your HP NetServer chassis.
Figure 3-1. NetServer E 45 Shelf Positions and Cabling Options
Use the guidelines in Table 3-1 to determine the proper location within
your HP NetServer E 45 to install your hard disk drive.
Table 3-1. Mass Storage Device Locations and SCSI ID Settings
Device
Standard Hard Drive
(in models that include
one)
HP Accessory 4 GB
HD (D4910A)
HP Accessory 9 GB
HD (D4911A)
HP SureStore T4i
HP SureStore 8i,
5000i, 2000i
Standard SCSI
Controller
24
Mount the Drive in the NetServer E 45
F5
SCSI Card
C33
PCI 1
D5
Shelf 5
*
Shelf 6
Location SCSI Address
Shelf 5 0 (default)
Shelf 3, 4, 5 or 6 0, if it is the first hard drive; for
subsequent drives, use address 1, 2
or 3
Shelf 3, 4, 5 or 6 0, if it is the first hard drive; for
subsequent drives, use address 1, 2
or 3
Shelf 3 or 4 4 (default)
Shelf 3 or 4 2 (default)
(can be set to any unused address)
PCI 1 Slot 7
Key
Available Connector
Engaged Connector
C33 50-pin SCSI Cable
D5 IDE CD-ROM Cable
Flexible Disk Cable
F5
* Built-in SCSI Terminator