Installing Processor Boards; Verify Contents - HP D5970A - NetServer - LCII User Manual

Chapter 6
9. If you have finished working with the satellite chassis, slide it back onto
the base chassis and lock it in place. (See Chapter 3.)

Installing Processor Boards

This section describes the installation of the 200 MHz/1 MB Processor Board
Accessory Kit in HP NetServer LXr Pro8 systems. The processor board includes
two 200 MHz/1 MB CPU chips, on which two heat pipes are mounted for
efficient cooling.
The HP NetServer LXr Pro8 comes standard with one 200 MHz/1MB processor
board and three terminator boards installed. You can install up to three
additional processor boards
For more information about the processor board, see the HP NetServer LXr Pro8
200 MHz/1 MB Processor Board Upgrade Guide.

Verify Contents

CAUTION
Do not remove the processor board from its bag until you are
ready to install it. Make sure the bag remains sealed. The
CPU chips are sensitive to humidity, so desiccant has been
packed in the bag containing the processor board. When the
processor board has been installed and the HP NetServer is
running, the chips are no longer sensitive to humidity.
Unpack the shipping box and verify that you received the contents listed below
for the 200 MHz/1 MB Processor Board Accessory Kit.
The upgrade kit should include:
Processor board - shown in Figure 6-3.
NOTE
Be sure to keep the bag around the processor board sealed
until you are ready to install the board.
HP NetServer LXr Pro8 200 MHz/1 MB Processor Board Upgrade Guide.
Update Return Kit that explains how to return unused terminator boards
to HP for environmentally safe disposal.
48
Installing Additional Boards