HP Color LaserJet 5500 Technical Reference Manual page 82

Variable
PRINTAREA
PRINTQUALITY
QTY
RENDERMODE
REPRINT
RESOLUTION
RESOURCESAVE
RESOURCE-
SAVESIZE
6-20 Environment Commands
General PJL Environment Variables
Description
INKEDAREA sets the DesignJet to shift the
plot to the top/left and advance the page cut in
order to save media.
Sets the default print quality for the current
PJL job.
Sets the number of collated copies of a job.
Sets the render mode for the personality.
Determines whether pages are reprinted after
a paper jam. When AUTO is selected and the
amount of RAM installed is below a printer-
specific threshold, pages are not reprinted
after a jam. If the amount of RAM installed is
more than this threshold, the pages are
reprinted. The ON setting causes the printer to
reprint the job after a paper jam. The OFF
setting disables reprinting.
Print resolution in dots per inch. When a job is
sent, if there is not enough memory to run
with the current resolution and page
protection configuration, the system
temporarily overrides the resolution and/or
page-protect values to run the job. When the
resolution is changed, memory is reconfigured
and all downloaded fonts, PCL macros, and
PostScript dictionaries are lost (however, no
I/O data is lost). Refer to "Commands that
Affect Printer Memory" in Appendix A.
Sets the value of the resource-saving variable.
(This variable is set as a personality-specific
variable using LPARM : personality.) Sets the
size of the resource saving area for the
specified personality if RESOURCESAVE=ON.
Sample Value
Range
FULLSIZE,
INKEDAREA
DRAFT,
NORMAL, HIGH
1 to 999
COLOR,
GRAYSCALE
AUTO, OFF, ON
300, 600
ON, OFF, AUTO
0 to maximum
available memory
(in 100 Kbyte
increments)